This model is designed as a teaching model for training the medical students, basic clinic nurses and first aid peoples to demonstrate and practice trachea intubation through mouth.
- Trachea intubation through mouth.
- Compare pupils: on is normal, another is large.
- Operator stand by the head of the model, raise the head to 80 degree, let the mouth larynx and trachea on the same line, then open the mouth.
- The left hands hold the throat mirror in right angle to the throat, extend into the tongue root, raise the mirror a little bit can see the epiglottis. Put the forepart of the mirror at the cross site of epiglottis and tongue root, raise the mirror a little bit can see the glottis.
- The right hand holds the trachea pipe and insert into the glottis. When the pipe goes into 1CM, the green light will be bright and come out the nice music, then goes deep into the trachea for 3-4CM again.
- If the red light bright and come out “du du du” noise, it indicate that the pipe goes error into the oesophagus, then should be pulled out and inserted again.
- Put the teeth pad to the side of the pipe, take out the mirror, fix the pipe and teeth pad by adhesive plaster.
- Inject suitable gas into the gasbag by injector, nip the end of the gasbag by the clamp.
- Connect the pipe with the breath instrument, press the gasbag to observe the lung expansion.
THE ADVANTAGE OF THE MODEL:
- The tongue is flexible and can be pressed down. Epiglottis can move follow the teeth root to expose the glottis to similar the clinic operation.
- Movable jaw and neck joint give the operator reality feeling.
- The sensor measures the location of the trachea pipe correctly. Console indicate the operation whether correct or not by bright and music.
- Demonstrate the normal pupil and large pupil.
- Use the model according to the correct method. After use, put the model into the sole box and keep it dry.
- The model should not be insolated in the sun light to avoid the distortion and fading.
- The people who is not familiar wit the model, please do not disassemble the model in case damage the parts.
- When the model is dirty us some detergent to clean it.
- The working voltage is 200-240V.
- Use the manostat when needed.